3. Getting started – regards complete IR detection kit
3.1. Unpacking
Before unpacking, verify if there are no visible damages of the package. Report them to the manufacturer or
the distributor.
3.2. Installation & connections
Mount the IR module in the measurement setup,
•
Connect all elements with cables provided in the package,
•
Make sure that all the elements are properly connected.
•
3.3. Switching on procedure
• Do not switch on the IR module power supply until ALL elements of the IR detection kit are properly connec-
ted with the proper cables,
• Switch on the thermoelectric cooler controller and wait until detector operating temperature is reached and
stabilized. Ready state will be indicated by the „LOCK" green LED light,
• Before starting the measurements make sure the load resistance is valid. IR module output should be termin -
ated by 50Ω or 1MΩ resistance depending on the bandwidth and is given in the test data provided on the
module,
• Do not manipulate any connectors on the active IR kit – this may introduce additional noises to the system or
can cause severe damages due to electrostatic discharges.
129/133 Poznanska St., 05-850 Ozarow Mazowiecki, Poland; tel. +48 22 733 54 20; fax +48 22 733 54 26; e-mail:
Please note: the information contained in this document is subject to change without further notification. VIGO System reserves the right to alter the performance and any resulting specifications.VS- 11-08-16MB
info@vigo.com.pl
8