Nuvo AccentPLUS1 Installation Manual page 3

Installation (Continued)
Once the speaker wire is connected to the speaker, center the speaker in
the cutout and secure it by turning the mounting screws clockwise until
the "dog ears" hold the speaker snug against the drywall, Fig 4. Be careful
not to over tighten the "dog-ears" .
When the speaker is in place, you can, if desired, position the pivotal
tweeter so it is directed toward the listening area of the room, Fig 5.
Install the grill by placing it over the speaker and applying pressure
around the outside edge. NOTE: Avoid pressure over the center of the
grill.
Painting the Speaker
If desired, the speaker grill and trim can be painted to match the wall
color. Each speaker is shipped with a clear plastic paint plug designed to
protect the inner components of the speaker during the painting process.
Always remove the grill from the speaker prior to painting. The
AccentPLUS1 speakers have a micro-perforation grill. To prevent the paint
from filling the holes and the grill and interfering with the speaker' s
sound distribution, the paint should be thinned at a ratio of 5 to 1 and
sprayed on the grill.
Fig. 4
For best results, we suggest that you paint the inside of the grill, as
well as the outside. The AccentPLUS1 speakers ship with a decorative
fiber backing on the inside of grill, which is easily removed for the
purposes of painting.
Once the installation is complete, your speakers should be fully opera-
tional. Should you have no audio from the speakers, make sure the
speaker wires did not become disconnected from the terminal posts,
or that there is not a short in the speaker wire.
Fig. 5
3