Changing A Wheel; Preparing The Vehicle - Mercedes-Benz E-Class Coupe Operator's Manual

nents damaged in this way may fail unexpect-
edly. There is a risk of an accident.
Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged
tires or chassis components replaced imme-
diately.
Mounting a wheel

Preparing the vehicle

Stop the vehicle on solid, non-slippery and
X
level ground.
Apply the parking brake.
X
Bring the front wheels into the straight-
X
ahead position.
Shift the transmission to position P.
X
Switch off the engine.
X
Vehicles without KEYLESS-GO: remove
X
the SmartKey from the ignition lock.
Vehicles with KEYLESS-GO: open the
X
driver's door.
The on-board electronics now have status
0. This is the same as the SmartKey having
been removed.
Vehicles with KEYLESS-GO: remove the
X
Start/Stop button from the ignition lock
( page 161).
Y
If included in the vehicle equipment,
X
remove the tire-change tool kit from the
vehicle ( page 322).
Y
Secure the vehicle to prevent it from rolling
X
away.

Changing a wheel

Securing the vehicle to prevent it from
rolling away
If your vehicle is equipped with a wheel chock,
it can be found in the tire-change tool kit
( page 322).
Y
The folding wheel chock is an additional
safety measure to prevent the vehicle from
rolling away, for example when changing a
wheel.
Fold both plates upwards :.
X
Fold out lower plate ;.
X
Guide the lugs on the lower plate fully into
X
the openings in base plate =.
Securing the vehicle on level ground (example:
Coupe)
On level ground: place chocks or other
X
suitable items under the front and rear of
the wheel that is diagonally opposite the
wheel you wish to change.
359
Z