Download Print this page

Halo Power Charge 2800 User Manual

Getting Started

Charge the HALO Power Charger until the LED displays solid Green. This may take up to 6

hours and will fluctuate depending on the charging power source.

Figure 1: Halo Charge it Charge Me 2in1 USB Cable

Using the supplied HALO Charge It Charge Me™ cable, plug one USB connector into the Halo

charger and plug the other USB connector to a computer or an AC power source with a USB 5V

input.

Note: The charging cable works in either direction, see Figure 1. (i.e. A is connected to the

power source and B is connected to the Halo charger, or B is connected to the power source

and A is connected to the Halo charger).

During charging of the HALO Power Charger, the LED will illuminate Red. When the charger is

100% fully charged, the LED will illuminate Green.

Table of Contents

Do you have a question about the Power Charge 2800 and is the answer not in the manual?

Page 1 Note: The charging cable works in either direction, see Figure 1. (i.e. A is connected to the power source and B is connected to the Halo charger, or B is connected to the power source and A is connected to the Halo charger).
Page 2 USB cable that was supplied with your personal electronic device.),press and hold the Power Button for about 2 seconds to begin charging. The Red LED will start flashing when the HALO Power Charger is out of power before shutting down.
Page 3 • Halo2Cloud, LLC will, subject to inspection, repair the defective product or replace it with a new or reconditioned unit. The return must be accompanied by a Return Materials Authorization (RMA) number to be issued upon request and must be shipped prepaid. A shipping rebate will only be extended to the customer in the event that a defect in material or workmanship is confirmed.