Universal Power Supply Installation Instructions Document Number 9000-A2-GN21-00 September 1997 The universal power supply is only installed on a 1-slot access unit, and is intended for international markets. Package Contents The shipping box contains a desktop (in-line) power transformer, with an attached cord and ferrite choke, for connecting to the access unit;...
Refer to the following table to verify that you have the appropriate power cord for the wall-plug standard in your country. Country Plug Standard Part Number Power Cord Description United BS1363 125-0075-0031 IEC 320-to-BS1363 – 2.5 M Kingdom Continental CEE-7/ 7 125-0074-0031 IEC 320-to-CEE-7/ 7 –...
Page 3
Installing the Power Supply and Cord 1. Insert the power supply’s 4-prong plug into the POWER jack. When inserting the plug at the rear of the access unit, align the plug with the notch above the POWER jack. Make sure the locking tab snaps securely into the jack. POWER PORT 1 PORT 2...
Troubleshooting Symptom Possible Cause Solutions No power, or none of the Power cord is not securely Check that the power cord system LEDs are lit. plugged into the wall power is securely attached at both outlet or the universal ends. power supply.