Page 2
Quail Digital approved parts should be used. If your installation requires more than one Base you will require Cat5 cable, two or more RJ45 plugs and crimping tool - and a LAN + RJ45 network cable tester. PRO7 HEADSET SYSTEM...
Installing the system The Base Station (Base) is a license-free DECT wireless transceiver using a 48v DC external power supply. The system can be expanded with multiple Bases, up to a maximum of 20, in a closed communications network linked by Cat5 cable. The typical range of the Base is up to 50 meters internally and up to 100 meters in open spaces.
(press for 15 seconds). Base Station Power Registration Cat5 Cat5 Power Button adaptor Status Bottom Micro Message For registration: press for 5 secs SD card volume To reset: press for 15 secs PRO7 HEADSET SYSTEM...
Page 5
Rules when installing multiple Bases on the same network • Ideal height for Bases is between 2 and 4 meters above floor level. • The maximum cable length between any two Bases should not exceed 100m. • The maximum cable length between two power sources should not exceed 200m.
Base in registration mode The system will time-out of this mode in 10 minutes but you can press the registration switch to exit the registration mode manually PRO7 HEADSET SYSTEM...
Positioning the charger The Headset Charger should be positioned on a worktop and plugged into a socket that is a constant 24hr power outlet. The charger should be located within range of a Base so that headsets remain active at all times. Return headsets to the charger when not in use.
As soon as a headset is registered, it is ready to use. Press the Registration Button again to exit the registration process or leave it to time-out after 10 minutes. PRO7 HEADSET SYSTEM...
Page 9
Audible tones for different headset status and functions: STATUS TONE Registration mode 1 beep every second Out of range 2 beeps every 10 seconds Battery low 3 beeps every 60 seconds Registration complete 1 long beep (3 seconds) Busy tone 3 long beeps Headset not registered 1 beep every 3 seconds...
REGISTRATION BUTTON Q-P7RS Function Activates registration and reboot functions on sites where Base is out of reach Cable requirements 2 core cable Dimensions HxWxD 52 x 63 x 87mm Weight ACCESSORIES NECKBAND Q-RH7NB HEADBAND Q-RH7HB BATTERY Q-RH7BAT PRO7 HEADSET SYSTEM...
Page 11
HEADSET Q-P7HS Operating frequency 1.88-1.90 GHz EMEA, Asia, 1.910-1.930 GHz North America Operating modes TalkLock and PTT as standard Microphone Noise cancelling, electric mic Battery capacity 6 hours TalkLock, 8 hours PTT Charge time 2.5 hours Volume control 5-stage, slide button up/down Battery (part number) Lithium Ion 3.7v (Q-RH7BAT) Weight...
Page 12
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. www.quaildigital.com...