Morphy Richards Power SteamPro User Manual page 7

RN330009MUK Rev2_Instruction Book 11/12/2013 14:57 Page 7
Using the Steam Generator for steam ironing (continued)
Remove the detachable water tank
squeezing the water tank release button (19). Lift
the filler cap (2), and fill with water to the max fill
line. Replace the water tank.
Turn the temperature dial
(see 'Temperature guide', page 5). The
temperature indicator light
the temperature is reached. Begin ironing when
the temperature indicator light goes out. If you
turn the temperature dial down, wait until the
temperature indicator light illuminates and then
goes off again.
The temperature indicator will cycle on and off
during ironing as it maintains its temperature.
3
(1) by
5
(5) to suit the garment
(11) illuminates until
7
When you have finished ironing, turn off the
appliance by pressing and holding the On/Off power
button
and both the power indicator
indicator
Disconnect the plug from the mains outlet.
Plug the appliance into a mains outlet and press
the On/Off power button (31)
A buzzer will be heard, the power indicator
will illuminate and the low steam indicator
will flash.
Press the steam level selector button
select the desired steam level. The relevant
steam level indicator (32/33/34)
flashing and illuminate constantly when the
steam level is reached.
For a strong, continuous flow of steam during
ironing, press and hold the iron steam trigger
to deliver steam through the soleplate (6).
NOTE: During use, the number displayed on the
steam pressure indicator (27)
will not interfere with how you use the product
or how it performs.
WARNING: The steam supply cord
hot during use.
(31) for two seconds. A buzzer will be heard
(28) and steam level
(32/33/34) will be extinguished.
4
to activate the unit.
(28)
(34)
6 6
4 4
(35) to
will stop
(4)
will change. This
(8) will get
7 7