Advertisement
2-3 Use a flathead screwdriver to disengage (Open) the socket actuator, as shown in figure 2-3a below.
The socket actuator should open after only a half turn, and then you should be able to remove the
processor with your fingers.
Hint: Make sure your system can accommodate the Intel Pentium M /Celeron M Processor that you want
to install. Check for motherboard, BIOS, and thermal compatibility by using the given documentation, or
by contacting the vendor if necessary. This processor should only be installed in systems supporting the
Intel Pentium M Processor.
2-4 Place new processor into the socket. Align processor's pin A1 (shown in figure 2-4) with the arrow on
the micro-FCPGA socket. Pin A1 of the processor is identified with an embroidered corner and pin A1 of
the socket is identified with a small arrow. If the processor does not drop completely into the socket, turn
the actuator until the processor drops in completely.
!!!You do not have to press down the processor. If the processor does not drop completely into the
socket, turn the actuator until the processor drops in completely.
Advertisement
