Clearing Label Jams; Resetting The Printer - LEITZ ICON User Manual

Leitz Icon Printer User Guide

Clearing Label Jams

The label guide latch also acts as a platen release.
To clear a label jam
1.Disconnect the power cord and battery from the printer to power off the printer.
2.Tear off any labels that have already fed through the label exit slot.
3.Push the button on the top of the printer to open the cartridge door.
4.Lift the label guide latch/platen release as shown.
3
5.Remove the label cartridge from the cartridge compartment, pulling the extruded labels from the label entrance slot.
6.Use a pair of scissors to cut off any labels that have exited the label cartridge.
If you think a partial label may be stuck in the printer, you can access the platen and cutter by removing the front panel of
the printer. See the video at www.leitz.com/icon/support for instructions on removing the printer panel.
The cutter blade is exposed when the front panel of the printer is removed. The blade is extremely sharp. Use caution
CAUTION:
when working with or near the cutter blade.

Resetting the Printer

You can reset the printer to the factory default settings. Resetting the printer reverts all settings to the factory default
settings. Any settings, including wireless settings, that have been changed are lost.
To reset the printer
1.Disconnect the power cord and battery from the printer to power off the printer.
2.With the printer off, press and hold the WPS button on the back of the printer and reconnect the power cord to the
printer.
3.Continue to hold the WPS button for five seconds, and then release the button.
4
20
Troubleshooting