Yamaha Motif XF Owner's Manual page 4

"TO DEVICE" on the rear panel of your Motif XF. You will see a
screen message that says "Connecting to USB device...".
6. Press the FILE button on the front panel of the Motif XF. You
should see the field next to "Type" highlighted and it should be
set to "all".
7. Press the cursor up button once, then use the INC/YES button
to select the file name "Studio Drums XF.n2.X3A" The name
should highlight.
8. Press the right cursor button once, so the "Type" field is
highlighted again, then press the right cursor button again to
move to and highlight the field next to "Load USR". Use either
the INC/YES button or the Data Wheel to change the field so it
reads "FL1" (if you only have one flashboard installed) or "FL1"
or "FL2" (if you have 2 flashboards installed – in other words,
the samples can be loaded to either of 2 flashboards installed).
9. If you are installing to a flashboard in slot 2 (FL 2), then you
must set the fields below Load USR as follows:
FL1 > FL2
FL2 > FL2
10. Press the SF2 button (Load). Then press the INC/YES
button once.
11. The library will start loading. You will first see the
onscreen message "Now Loading..." and then shortly after you
will see an onscreen message that says "Now Installing to the
Flash Expansion Memory Module". THIS WILL TAKE AWHILE
because the samples are being "burned" onto the Flashboard,
where they will remain even when you power off your XF. Do
not turn off your XF during this process, even if you think
it's "stuck" – it isn't. Powering off your XF during the Flash
load can result in a corrupted flashboard.
12. The Flash load process will finish and you will see
another "Now Loading"... message onscreen, then the load
process will complete.
13. Press the VOICE button on the XF, then Press the USR
DR bank button, and press A 1 to select the first drumkit, which
is "Ambient Kit".