Cruise Control; Headlamps - High Beam - Cadillac 2005 LeSabre Getting To Know Manual

Rainsense™ Wipers (if equipped)
The Rainsense system monitors the
amount of moisture on the windshield
and automatically operates the wipers
as needed, depending on driving condi-
tions and the sensitivity setting. The
moisture sensor is mounted on the inte-
rior side of the windshield behind the
rearview mirror.
The Rainsense wipers operate in a
delay mode as well as a continuous low
or high speed as needed. If the system
is left on for long periods of time, occa-
sional wipes may occur without any
moisture on the windshield to indicate
the system is active.
To activate the Rainsense wipers:
Turn the wiper band to one of the five
sensitivity levels within the delay area.
The position closest to OFF is the low-
est sensitivity level. Each higher sensi-
tivity level increases the frequency of
wipes. The system can be overridden at
any time by manually turning the wiper
band to LO or HI speed.
Turn the Rainsense
Notice:
wipers off to avoid wiper damage
when going through an automatic
car wash.
See Section 3 of your Owner Manual.

Cruise Control

Set Cruise Control
The Cruise Control buttons are located
on the steering wheel. Press the
ON/OFF button to turn Cruise Control
on. Accelerate to the speed you want
to set.
Press the SET/COAST button. The
Cruise Control light on the instrument
cluster will illuminate. Remove your foot
from the accelerator pedal.
Resume Set Speed
Applying the brakes will turn the Cruise
Control off.
Press the RESUME/ACCEL button.
The vehicle's preset speed will resume.
OFF
Press ON/OFF or step on the brake
pedal.
See Section 3 of your Owner Manual.
Headlamps — High Beam
High/Low Beam Changer
Pull the turn signal lever toward you until
it clicks to change from low beam to
high beam.
Flash-To-Pass
Pull and hold the turn signal lever toward
you briefly to flash the headlamps.
See Section 3 of your Owner Manual.
11