Saving Photographic Data To Smartmedia - Minolta DS-100 Instruction Manual

Saving Photographic Data to SmartMedia

The Maxxum/Dynax 7 camera can store up to 7 rolls of
films' photographic data.
1. Insert the card into the card slot and close
the door.
2. Press the WRITE buton until the green
ACCESS lamp starts to blink.
• The Data Saver DS-100 takes the data from the camera
and stores it onto the SmartMedia card.
• When the DATA FULL lamp blinks (yellow), the card
does not have enough capacity. To overwrite stored
data, refer to page 18.
E16
When data is bering recorded, the ACCESS lamp
(green) will blink.
• The Data Saver DS-100 takes the data from the camera
and stores it onto the SmartMedia card. So even if the
same data is on the card, it will be overwritten.
• The data recording time depends on the capacity of the
card.
• Do not remove the card while data is being recorded.
Capacity Maximum recording
of card time for 7 rolls of film
(approximate)
2MB 27 seconds
4MB 41
8MB 42
16MB 73
32MB 74
E17