Display Information - Minolta DS-100 Instruction Manual

Display Information

When using the WRITE and FORMAT buttons, they must be pressed for a mini-
mum of 3 seconds for the signals to be processed properly.
Display Explanation
When camera main The DS-100 is suc-
cessfully connected
switch is turned on, the
to the camera.
ACCESS lamp (green)
is on for 5 seconds.
ACCESS lamp (green)
Writing data
blinks.
DATA FULL lamp
Card does not have
(yellow) - blinks
enough capacity to
hold the data.
E44
Action Page
13
Do not remove the
SmartMedia card from the 16
DS-100 while saving data.
• Replace card
• Overwrite by pressing
18
WRITE button until
ACCESS lamp turns green.
Display Explanation
ACCESS (red) and
SmartMedia card is not
DATA FULL (yellow)
properly formatted.
lamps blink slowly.
• No card in DS-100
• The write protect seal is
ACCESS (red) and
on the card.
DATA FULL (yellow)
• The SmartMedia card
lamps blink rapidly.
does not meet the
required specifications.
Remove the DS-100 from the camera and re-
Lamps do not
attach. If problem persist, contact an authorized
illuminate.
Minolta Service Facility.
Action Page
Simultaneously press
the FORMAT and 14
WRITE buttons.
• Insert card into DS-100
• Remove the write pro-
tect seal
11
• Insert a correct (3.3v)
card ino the DS-100.
12
E45