Table of Contents
Advertisement
Product Information Guide
signals, if in doubt, check with the manufacturer. For personal medical
devices (such as pacemakers and hearing aids), consult with your
physician or the manufacturer to determine if they are adequately shielded
from external RF signals.
There are some places where RF signals could constitute a hazard, such
as health care facilities, and construction sites. If you are not sure, look
around for signs indicating that two-way radios or cell phones should be
turned off.
In addition, turn off and do not charge your device if you are in any area
with a potentially explosive atmosphere, as sparks in such areas could
cause an explosion or fire. Such areas are usually, but not always, clearly
identified, and include areas where you would normally be advised to turn
off your vehicle engine.
FCC Compliance Statement
This device and its related accessories like the adapter (the "Products")
comply with Part 15 of the FCC Rules. Operation of each Product is
subject to the following two conditions: (1) each Product may not cause
harmful interference, and (2) each Product must accept any interference
received, including interference that may cause undesired operation.
Note: The Products have been tested and found to comply with the limits
for a Class B digital device or external switching power supply, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection. The Products generate, use and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If a Product does cause harmful interference to radio or
television reception, which can be determined by turning the Product off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
106
Advertisement
Table of Contents
