Superior DRT63STYN Installation And Operation Instructions Manual page 24

INNOVATIVE HEARTH PRODUCTS • SEE-THROUGH POWER VENT DV GAS FIREPLACES (DRT63STYN) • INSTALLATION INSTRUCTIONS
120V AC
Junction Box
Hot
Neutral
Ground
B W
G
AC/DC
Power Adaptor
Wall
Receiver
Wiring Color Code
B = Black BR = Brown
BL = Blue G = Green
Figure 32: Electronic Wiring Diagram
J-BOX/RECEPTIACLE
WIRING
120V, 60HZ, 1PH
Junction Box
Black
Tab Intact
Field Wired
Factory Wired
Figure 33: Junction Box Wiring
24
ELECTRONIC WIRING DIAGRAM FOR POWER VENT FIREPLACES
Ground
Exhaust
NOT USED
Blower
Control
Module
B B
G
W
102663-01
Pressure
Switch
GY
R
Hi-Temp Sleeve
Cable Harness 102661-01
GY = Gray PU = Purple R = Red
O= Orange W = White Y = Yellow
Step 5. REMOVE GLASS DOOR
ASSEMBLY (ON CONTROL SIDE)
• Handle this glass with extreme
• Do not attempt to substitute the
Tab
Intact
Hot
Side of
Receptacle
• The glass door of this appli-
Neutral
Side of
Receptacle
Green
Ground
Screw
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
B
BR
Exhaust Blower
(Field Installed)
O
W
G
G
Y
B
BR
O
Y
W
G
BL
PU
WARNING
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
materials used on this door,
or replace cracked or broken
glass with any materials other
than those provided by the
appliance manufacturer.
ance must only be replaced
as a complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked or chipped glass
separately.
Electronic Pilot Assembly
Hood
Y
O
Pilot
Tube
Pilot
Proflame Valve
Ground
Electronic Modulation
Wire
DFC Wire Harness 102662-01
Y
G
O
W
W
G
BL
PU
THIS CONNECTOR
NOT USED ON POWER
VENT UNITS
Remove Barrier (see Notice, Page 34)
This fireplace comes with a barrier to reduce the
likelihood of burns from touching hot glass. If
the barrier is damaged, the fireplace should be
turned off immediately and the fireplace must
not be operated until a new, approved factory
barrier for this unit is installed.
NOTE: It will be nexcessary to remove the barrier
filler frim piece. Upon reinstall, insure that the
tabs on the barrier filler are engaged with the
slots in the base of the fireplace.
To remove barrier follow these steps.
1.Lift barrier up by the frame at the top.
2.Remove lower filler piece by pulling down
off of the barrier.
3.Lower barrier and push barrier to left to
release right side.
4.Pull the right side out of fireplace.
5.Remove barrier.
Glass Door Assembly
If not already done, remove the glass door
assembly on the control side of the fireplace
(see Page 31).
Igniter Rod
Flame
Sensor
B
Spark Wire Cable
R
Y
Pilot Sensor Cable
Proflame
DFC Board