Hobie T2 Owner's Manual page 20

Hobie Cat®
Owner's manual - Hobie T2
Mast Set-up : Wire Assembly
Illustration
With the base of the mast facing towards the front of the boat, lay the mast on top of the boat. (place some padding un-
der the mast to prevent scratching). Put the wires on each side of the boat.
Spinnaker Option:
Insert the spi halyard into the small block at the top of the mast (see the drawing for the mounting of the spinnaker at
the end of this manual).
CAUTION DANGER : ALUMINIUM MAST
STAY AWAY FROM ELECTRICAL WIRES
CONTACT WITH ELECTRICAL WIRES MAY CAUSE DEATH
Steps Description
Connect the shrouds to the stay adjuster on the hull, using
the clevis pins and the split rings.
At this stage, attach them in the upper hole. The position
may be changed afterwards.
9
The position in the stay adjuster determines the mast rake.
You can pull the cover partially over the stay adjusters at
this time. The assembly of the trapeze wires can wait until
after you have raised the mast.
20