GE GTMP280EDWW Use And Care Manual page 10

Electric Dryer
EXHAUSTING
LO R R
TALLATIONS
T EXHA T
NO
LOSE TALLA
S.
ALCO LOSE
6
If your dryer is approved for installation in an alcove or closet,
it will be stated on a label on the dryer back.
The dryer MUST be vented to the outdoors. See the EXHAUST
INFORMATION sections 3 & 4.
Minimum clearance between dryer cabinet and adjacent walls
or other surfaces is:
0 in. either side
7.6 cm (3 in.) front and rear
ceiling, etc. is 109 cm (43 in.) without pedestal, 140 cm (55 in.)
with pedestal.
Closet doors must be louvered or otherwise ventilated and
must contain a minimum of 387 sq. cm (60 sq. in.) of open area
equally distributed. If the closet contains both a washer and
a dryer, doors must contain a minimum of 774 sq. cm (120 sq.
in.) of open area equally distributed.
NO EXHA
RE RYER
BATHR
7
INSTALLATION
The dryer MUST be vented to the outdoors. See EXHAUST
INFORMATION section 3 & 4.
The installation must conform with local codes or, in the
absence of local codes, with the current CSA C22.1 Canadian
Electrical code part 1.
8
INSTALLATION
Installation must conform to the current CAN/CSA Z240 MH
series Mobile Home Installation Codes.
The dryer MUST be vented to the outdoors with the
termination securely fastened to the mobile home structure.
(See EXHAUST INFORMATION section 3 & 4.)
The vent MUST NOT be terminated beneath a mobile or
manufactured home.
The vent duct material MUST BE METAL.
Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
See section 2 for electrical connection information.
10
C T
R C
S.
R ATHR LCOVE
EXHA TO
TALLATION
LOCA A
E R
R
A
R EXHA
9
BOTT
EXHA
T C
LY RO
T E
REMOVE
SCREW
AND SAVE.
Detach and remove the bottom, right or left side knockout as
desired. Remove the screw inside the dryer exhaust duct and
save. Pull the duct out of the dryer.
Cut the duct as shown and keep portion A.
T LOCATION
BEND TAB
UP 45º
Through the rear opening, locate the tab in the middle of the
appliance base. Lift the tab to about 45º
screwdriver.
T T
ET
TALLA
R R
YOUR
R
ET.
LOVES.
REMOVE
DESIRED
KNOCKOUT
(ONE ONLY).
FIXING HOLE
22.9 cm (9.0")