North American BB12482G / TR-F-04-B-NCT-1 Assembly And Operating Instructions Manual page 10

Step 5
- Attach the timer and regulator hose assembly (17) to the Burner (9) as shown below in Figure G.
- Secure the Electric Igniter (12) to the front right leg (6) by removing the plastic cap and bolt,
inserting the igniter through the back of the leg, and then replacing the cap and bolt onto the
igniter from the front.
- Insert the igniter wire (16) through the hole in the upright on the bottom of the burner basket as
shown below in Figure H. The metal tip of the igniter should sit just inside the burner. Secure the
Igniter Wire in place by attaching it to the upright using Bolt (B) & Nut (F).
- Insert the other end of the wire into the back of the Electric Igniter (12) on the right front leg as
shown in Figure H1.
Note: It is recommended to keep about 1/8"~1/5" distance between the igniter
and the inside edge of the burner
Figure H
Figure G
Figure H1
10