Sharp SJ-21P-GY Service Manual page 17

1. Stick A-sealer FM to Motor holder.
A
A
finish start
Fig. A-10
2. Insert the fasten terminal of Defrost thermo. ass'y
into the terminal of Fan motor. (2 pcs.)
Defrost thermo. ass'y has positive lock. (No. pole, so
changeable)
Check locking by pulling them with more than
10N(1kgf), all wires after assemble them.
NOTE
(1) Assemble so that terminal of Fan motor does not
deform.
(2) Take care not to stress to terminal of Fan motor after
wiring.
terminal
fasten terminal
Fig. A-11
3. Set Motor cushion and " 2 " ass'y to " 1 " ass'y.
wire
View from B
B
Fig. A-12
4. Insert the wire of Defrost thermo. ass'y to the place
of " 3 " ass'y as shown in Fig. A-12.
5. Set Motor cushion and Motor cover to " 4 " ass'y as
shown Fig. A-13.
Motor
holder
A-sealer
Sec. AA
FM
Defrost thermo. ass'y
Fan motor
" 2 "ass'y
" 1 "ass'y
A-sealer FM
Motor cover
Sec. Horizontal Center
A-sealer FM
Motor cover
Motor cushion
A-sealer FM
Sec. Length Center
Fig. A-13
6. Set Defrost thermo. ass'y to " 5 " ass'y as shown in
Fig. A-14.
Defrost thermo.
ass'y
C
C
Thermostat sensing face (aluminum side)
should be fixed horizontally, lower side.
Insert
Fastening band A
before
Sec. CC
Fig. A-14
17
Fan motor
Motor cushion
Motor holder
A-sealer FM
Motor cushion
Motor holder
Motor cushion
Fan motor
" 5 " ass'y
D
D
Insert
wires wires
after before after
Sec. DD
SJ-21P
SJ-D25P