Table of Contents
Advertisement
Chapter 2: Installation
Before flush mounting the V104n
•
Determine your mounting orientation. See "Mounting Orientation"
on page 9 for more information.
•
Choose a location that meets the mounting location requirements.
•
Using the fixed base as a template, mark and drill the mounting
holes as necessary for the mounting surface.
Flush mounting the V104n
1.
Mark the mounting hole centers and connector center on the
mounting surface.
2.
Place the V104n over the marks to ensure the planned hole centers
align with the true hole centers (adjusting as necessary).
3.
Use a center punch to mark the hole centers.
4.
Drill the mounting holes to a diameter of 6.8mm (0.26 in)
appropriate for the surface.
5.
Drill the connector hole to a diameter of 28.6mm (1.13 in)
appropriate for the surface.
6.
Pull the cable through the center connector hole and attach the
cable directly to the V104n, ensuring the connector is fastened
securely to the unit.
7.
Place the V104n over the mounting holes and insert the mounting
screws through the top of the V104n and through the mounting
surface.
8.
Use two M6 washers and M6 nuts to secure the V104n to the
mounting plate (washers and nuts not included).
resulting from over-tightening is not covered by the warranty.
When installing the V104n, hand tighten only. Damage
16
Advertisement
Table of Contents
