Table of Contents
Related Manuals for K&F SONA SUB
Summary of Contents for K&F SONA SUB
- Page 1 K&FSONASUB Revison 1.2 User'sManual Released: 04.05.2010 ImportantInformation, PleaseReadBeforeUse! KLING & FREITAG GmbH Junkersstraße 14 D-30179 Hannover TEL +49 (0) 511 96 99 70 FAX +49 (0) 511 67 37 94 www.kling-freitag.de...
-
Page 3: Table Of Contents
Notes for Mounting the Speakers Preventing hearing damage Protecting the Speakers / Operating Safety WallandCeilingInstallation CorrectRatiobetweenTopandBassSpeakers Level increase because of adjacent areas ConfigurationandConnectingDiagram Terminal assignment SONA SUB with 'SONA 5 unfiltered' SONA SUB with 'SONA 5 filtered' Wiring Wiring instructions OperatingtheSpeakers TechnicalSpecifications Measuringdiagrams Dimensions Disposal 12.1... -
Page 4: Introduction
Thank you for your decision to buy a KLING & FREITAG sound system. To guarantee a trouble-free op- erating of the equipment and to allow your KLING & FREITAG SONA SUB system to achieve its full potential please read the operating instructions carefully before use. With the purchase of a SONA SUB system, you have acquired a large sound system with the highest possible quality and perfor- mance capabilities. - Page 5 K&F SONA SUB ProductDescription The subwoofer SONA SUB is the ideal bass supplement for the speaker SONA 5. With its discreet ap- pearance, it fits in nearly any architecture. The practical mounting points with a double keyhole design enable wall and ceiling installation. In addition to possible use with the K&F Controller CD 44, it can also be operated with a universal electronic crossover.
-
Page 6: Required Signal Processor
User's manual K&F SONA SUB Requiredsignalprocessor When using the SONA SUB, a signal processor is required such as an electronic crossover or the K&F Controller CD 44. The signal processor must provide at least the following settings: • 1 x high-pass 4th order Butterworth •... - Page 7 User's manual K&F SONA SUB SafetyInstructions MountingtheSpeakers/WallandCeilingInstallation The speakers may only be mounted to wall and ceilings by qualified personnel. The technicians responsible for assembling the speakers on site are responsible for the safe setup and use of the speakers and guarantee this.
- Page 8 Connecting Diagram] from page 13. OperationswithCD44Controller: • For optimal performance and operating safety of the SONA SUB speakers we recommend using the system controller K&F CD 44. • When operating the loudspeaker with amplifers without clipping limiter and nominal amplifier power less than 75W@8Ω...
- Page 9 User's manual K&F SONA SUB WallandCeilingInstallation Using the provided drilling plan, mark the mounting points on the wall or ceiling. When mounting, always choose at least two of the mounting points as well as the fixation point. Choose fasteners that are suitable for the wall or ceiling material. Use suitable rawlplugs if necessary.
- Page 10 User's manual K&F SONA SUB Remove the grille: Push one side of the grille towards the middle of the speaker (1). Keep pushing the side and, while doing so, slide the side of the grille upwards out of the fastening groove (2).
- Page 11 User's manual K&F SONA SUB Re-install the grille. To install the grille, follow the removal instructions in reverse order. Then push on the grille so that fold of the grille (1) is securely behind the fastening groove (2). KLING & FREITAG GMBH © 2010 Revision 1.2...
- Page 12 SONA SUB can be combined with 2 tops SONA 5. This is valid as long as the amplifiers for SONA SUB and SONA 5 have the same overall gain and the SONA SUB is mounted on a wall or on the open floor (reference use).
- Page 13 User's manual K&F SONA SUB ConfigurationandConnectingDiagram Terminalassignment KLING & FREITAG GMBH © 2010 Revision 1.2 Page 13 of 21...
-
Page 14: Sona Sub With 'Sona 5 Unfiltered
User's manual K&F SONA SUB SONASUBwith'SONA5unfiltered' Inthismode,thepolarityoftheSONA5’sinputsignalmustbereversed. SONA 5 SONA 5 SONA SUB Amplifier Amplifier Signal Processor STEREO MONO MIX Signalprocessorsettings SONASUB High-pass, 32Hz, 4th order Butterworth Low-pass, 80Hz, 3rd order Butterworth Bell filter, 45Hz, +2dB, KLING & FREITAG GMBH © 2010 Revision 1.2... -
Page 15: Sona Sub With 'Sona 5 Filtered
4th order Butterworth Low-pass, 80Hz, 3rd order Butterworth SONASUB: Bell filter, 45Hz, +2dB, In the CD 44, choose the LSBlock [SONA SUB] for the speaker SONA SUB. All-pass, 130Hz, SONA5: 1st order, Q=0 In the CD 44, choose the LSBlock [SONA 5] for SONA5:... -
Page 16: Wiring
Phoenix plug, the Phoenix connector’s contacts have hazardous contact voltage! Wiringinstructions • Before connecting your SONA SUB loudspeaker switch off all equipment and turn down all level controls. • Only use high-quality speaker cables with a sufficient wire gauge. The wire gauge depends on the length of the speaker cable. - Page 17 Switch off all equipment and turn down all level controls of the mixing console and the power amplifiers. • Wire your SONA SUB systems according to the instructions in this manual. Important • Switch on the mixing console first, then the controller and the power amplifier. Always use the before mentioned switching order.
- Page 18 User's manual K&F SONA SUB TechnicalSpecifications Design Bass reflex system Frequency range without filter (+/-3 dB / -10 dB) 70 Hz -400 Hz / 60 Hz - 450 Hz Lower cut-off frequency with filter (-3 dB / -10 dB) 42 Hz / 32 Hz (half space)
- Page 19 User's manual K&F SONA SUB 10. Measuringdiagrams Frequency response (unfiltered) Impedance (Ohm) 1000 Frequency (Hz) Frequency response SONA SUB filtered Frequency response SONA 5 unfiltered Frequency response SONA 5 filtered Summed Frequency response filtered 1000 10000 20000 Frequency (Hz) KLING & FREITAG GMBH © 2010 Revision 1.2...
-
Page 20: 11. Dimensions
User's manual K&F SONA SUB 11. Dimensions 308,0 mm / 12,126" 25,5 mm / 1,004" 224,0 mm / 8,819" 17,5 mm / 0,689" KLING & FREITAG GMBH © 2010 Revision 1.2 Page 20 of 21... -
Page 21: 12. Disposal
User's manual K&F SONA SUB 12. Disposal 12.1 RegulationsforDisposal 12.1.1 Germany Itisnotallowedtodisposeofusedelectricalequipmentasdomesticwaste. Disposeofthedeviceatpubliccollectionpointsforrecycling! The device is a so called dual-use product intended for domestic and commercial use. Therefore this device can be disposed of in public collection/recycling points, contrary to Kling & Freitag products which are limited to commercial use.