Installing The Batteries; Assembling Your Detector - Tesoro LOBO SUPER TRAQ Operator's Instruction Manual

Lobo SuperTraq Operator Instruction Manual
1 Operator Instruction Manual
If any of these items are missing, contact the Tesoro Authorized Dealer where you purchased your
detector immediately.
Assembly of the Lobo SuperTRAQ is simple and requires no special tools. Just install the batteries,
mount the searchcoil on the lower pole assembly, connect the three pole assemblies, wrap the excess
cable around the pole and plug the cable into the control housing. Finally, adjust the pole length and
searchcoil angle and you're ready!

INSTALLING THE BATTERIES

Your LOBO SuperTRAQ is equipped with a special battery test circuit so that you can always be sure
you are getting top performance from the detector.
To install or replace the batteries, first make sure the THRESHOLD control is set to OFF—turned
completely counterclockwise past the "click."
Remove the battery door from the back of the control housing. Do this by pulling the battery door's two
nylatch plungers out until the door pops off.
Remove the battery packs. Place 4 fresh AA size alkaline cells into each pack, observing polarity as
marked on the battery packs. Make certain the polarity snaps fit properly. A poor connection may cause
the detector to act erratically or fail to operate completely.
Place the battery packs into the battery compartment without pulling or stretching the battery lead wires.
Replace the battery door by placing the door into its original position and then pushing in on the nylatch
plungers to lock the door into place.

ASSEMBLING YOUR DETECTOR

1.
Remove the mounting screw and thumb nut from the black
nylon pole tip mounted on the end of the lower pole.
2.
Insert the pole tip between the mounting ears of the searchcoil
3 sur 18
http://tesoro.com/LoboSuperTraq_Manual.htm
21/06/2007 14:36