Routing Setup - D-Link DSL-2740B User Manual

Section 3 – Configuration

ROUTING SETUP

The Static Route and RIP type routing configurations can be performed here
To access the ROUTING SETUP setting window, click on the Routing Setup button under the ADVANCE tab.
STATIC ROUTE
Enter the destination network address,
subnet mask, gateway AND/OR available
WAN interface then click "Apply" to add the
entry to the routing table.
RIP
To activate RIP service, select the desired
RIP version and operation, followed by
placing a check in the 'Enabled' checkbox for
the interface. To stop RIP service, uncheck
the 'Enable' checkbox for the interface. Click
the 'Save/Apply' button to save the
configuration and to start or stop RIP.
NOTE: RIP cannot be configured on the WAN
interface which has NAT enabled (such as
PPPoE).
D-Link DSL-2740B User Manual 62