Page 1
IMPORTANT INSTRUCTIONS & OPERATING MANUAL Model: MFE5048WL / BG-50B Model: MFE5060WL / BG-60B Cynergy Log Linear Wall Mounted Electric Fireplace Read these instructions carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and / or property damage.
IMPORTANT: IMPORTANT: IMPORTANT:It It It It is is is is important important important important to to to to read read read these these instructions instructions carefully carefully before before using using appliance appliance IMPORTANT: read these these instructions instructions carefully carefully before before using using the...
UNPACKING AND TESTING APPLIANCE Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance operates properly by plugging the power supply cord into a conveniently located 110-120 Volt grounded outlet. 【Grounding Grounding Grounding Appliance Appliance...
Page 4
Put the Fireplace box into the wall, there're two hanger brackets in both sides of the fireplacebox, using ST4X ST4X 6 pcs of ST4X ST4X 16 16 screws(each side with 3 screws) to lock the fireplace in the wooden wall Figure (C) After firmly installed the Fireplacebox, then move the Glass Panel back to the Fireplacebox, using (A), (A),...
【 【 【 【 Safety instructions】 】 】 】 Safety Safety instructions instructions Safety instructions Only use the appliance in accordance with the instructions in this manual! It cannot be used for any other purpose. Never operate the appliance when the appliance itself or the main cable show any signs of damage. In order to avoid overheating, do not cover the heater.
Page 6
【 【 【 【 Instruction Panel】 】 】 】 Instruction Instruction Remote Remote Controller Controller Switch Switch Panel Panel Instruction for for Remote Remote Controller Controller and and Switch Switch Panel Control Panel / Remote Control Operation (Control panel POWER switch must be ON to use remote control.) BUTTON FUNCTION ACTION &...
When the heater is first turned on, a slight odor may be present. This is normal and NOTICE should not occur again unless the heater is not used for a long period of time. To improve operation, aim the remote control at the front of the fireplace. DO NOT NOTICE press the buttons too quickly.
Page 8
CAUTION: CAUTION: sharp sharp edges! edges! CAUTION: CAUTION: sharp sharp edges! edges! 1. After installation, the power plug should be accessible. 2. If the power cord is damaged. It must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Need help?
Do you have a question about the MFE5048 and is the answer not in the manual?
Questions and answers