Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bladelius Thor
Summary of Contents for Bladelius Thor
- Page 1 Bladelius Thor...
-
Page 2: Table Of Contents
TaBle OF CONTeNTS Warnings and Information Introduction “Burn-In” Design Balanced signal transmission Unpacking Placement Cleaning Rear panel Front panel Remote control Input settings Input level Name Surround mode Installing/Changing batteries in the remote control Troubleshooting Warranty Obtaining Service... -
Page 3: Warnings And Information
(electromagnetic Compatibility)and lVD (low Voltage Directive) standards of the european Community. The information contained in the manual is subject to change without notice. The most cur- rent version of this manual will be posted on our web site at http://www.bladelius.com. -
Page 4: Introduction
5-6 weeks of operation, in order to speed the “burn-in” process. For best results, the Thor should be left on or in the standby mode at all times. The unit should not be switched off by removing the power cord unless the unit will not be used for a significant period of time (during vacations, etc.). -
Page 5: Unpacking
We suggest that you to keep your box and shock absorbers. Save your plastic bag, inserts, and carton. You may need these later for transporting the Thor or for shipment in the event it ever requires factory service. -
Page 6: Rear Panel
Rear Panel 1. PRe OUT If you want to use your Thor as a pre-amp, just connect your power amplifier to the Pre out with RCa connectors. 2. TaPe OUT Make sure you connect your inputs and outputs of the Right and left channels consistently;... -
Page 7: Front Panel
Front panel 1. STaND BY For best results, the Thor should be left on or in the standby mode at all times. The unit should not be switched off by removing the power cord unless the unit will not be used for a significant period of time (during vacations, etc.). -
Page 8: Remote Control
System Remote control Please note that this is a system remote control which means that it can also control other BlaDelIUS products. Several functions do not apply to this amplifier. activates amp specific control buttons Stand By Switches the amplifier on and off... -
Page 9: Input Settings
Select which in- put you want to connect to the TaPe OUT connectors on the back of your Thor. You can now use TaPe OUT as an input to your surround sound processor. TaPe is then used as your input coming back from the surround sound processor and will be connected to the internal amplifier. -
Page 10: Installing/Changing Batteries In The Remote Control
INSTallINg/ChaNgINg BaTTeRIeS IN The ReMOTe CONTROl This remote control uses two aaa 1.5V batteries. OPeN/ ClOSe The BaTTeRY COVeR Remove the 2 screws that hold the cover on the back of the remote. When replacing the batteries please be sure to match the batteries with the (+) and (–) markings inside the battery compartment during installation. -
Page 11: Troubleshooting
If the same channel stays out, it indicates trouble could be with something other than your preamp. 2.) The Thor preamplifier is completely controlled by the remote control handset. If the unit does not respond to commands from the remote control, the useful life of the batteries may have expired. -
Page 12: Warranty
Neither BlaDelIUS nor your dealer can be responsible for ship- ping damage due to improper (that is, non-original) packaging. - Page 13 Bladelius http://www.bladelius.com...
Need help?
Do you have a question about the Thor and is the answer not in the manual?
Questions and answers