NEC VN-23 User Manual page 31

When you want to decrease or increase the recording time by 5 minutes up to 8 hours maximum.
0 3S Program Mode 0 Start Time Setting
0
End Time Setting ® Timer Stand-by Mode
Press the 3S button on
the remote control.
Press the START + or -
button to set the START
time.
Press the END + or - but-
ton to set the END time.
After 9 seconds, following
advice will appear on the
screen.
FOR THE PROGRAM RECORDING
1. INSERT THE CASSETTE
2. TURN VCR OFF
3S PROGRAM 1
13S PROGRAM 1
I
3S PROGRAM 1
CH
:
06
DATE
:
TODAY
START
:
10D0
END :12:00
8 SECONDS WAIT
CH :06
DATE
:
TODAY
START
:
10:00
END :12:00
8 SECONDS WAIT
CH :06
DATE
:
TODAY
START
:
10:00
END :12:00
8 SECONDS WAIT
3S FROG ICANCEL
I
CANCEL 3S pROG. I CANCEL] CANCEL 3S pRoa ' C ANCEL' CANCEL
START
-F/-
END +/-
START CORRECT
END CORRECT
START +/-
END +1-
START CORRECT
END CORRECT
START +/-
END +1
START CORRECT
END CORRECT
Whenever pressing the END
- or + button, the time is
decreased or increased by
minutes.
5
Press the OPERATE button.
The power will be off and
TIMER REC indicator will
light.
Recording channel is automatically set to the current channel which you are viewing.
But, if necessary, the change of the current channel can be done by simple button operation as follows.
• To change the channel, adjust with CH el or
e
button.
NOTE:
1. The 3S Timer Programming function allows you to record programs as long as 3 days in advance.
2. To change the START time, adjust with 'START +/-' buttons (short pressing: 5 minutes, Long pressing: 10 minutes).
3. There is no need to set END time because it is automatically set to stop recording after 2 hours from the START time.
When you want to decrease or increase the recording time, you can adjust the END tme by 5 minutes up to 6 hours max-
imum by pressing th 'END + or -' button.
4. The programs by the 3S Timer Recording are recorded only at 'SINGLE' Program mode.
(See page 24 for more detailed information of PROGRAM MODE)
5. To check or cancel timer programs, please see pages 31.
29