Bticino 3550 Installation Manual page 106

Temperature control unit
4 SWITCHING ON FOR THE FIRST TIME
4.5 Configuring the pumps
L i v i n g r o o m
Z o n e t e s t . . .
C O N F I G U R E Z O N E S
1 : L i v i n g r o o m
2 : Z o n e 2
3 : Z o n e 3
P u m p s
On pressing the CLEAR key the
configuration set is sent to the zone
The control unit sends the configuration:
The following error message may be given
L i v i n g r o o m
E R R O R
V e r i f y t h e p r o b e
c o n f i g u r a t i o n
Make sure that the probe is in configuration
(P = CEN) and try again; if it is not in this
configuration, it cannot be configured via
the control unit.
106