Features And Specifications - Jensen POWER 1500.5D Installation & Operation Manual

POWER 1500.50 5-Channel Amplifier
Features and Specifications
Your new Jensen Power mobile stereo power amplifier is the amplifer of
choice for the high demands of auto sound reproduction. With its deep-bass
reproduction and plenty of reserve power, low harmonic distortion and neutral
reproduction, the Power series of amplifiers takes Mobile Hi-Fi to new heights.
Like all Jensen products, when it comes to accurate sound reproduction the
Power series takes a back seat to no one. Jensen will bring your Hi-Fi
experience to new heights with the following features:
• High Current MOSFET Power Supply and Output Transistors
• Optimized Class Ddesign Minimizes Distortion and Reduces Idle Current.
• Easily Drives 2-0 hm Loads
• Full range Highpass Filter: Continuously Variable 16Hz -160Hz
• Subwoofer Infra -Sonic Filter: ContinuouslyVariable16Hz -60Hz
• Subwoofer Low Pass Filter: Continuously Variable 30Hz-160Hz
• Subwoofer Bass EQ Filter: Continuously Variable 0-12dB@ 45Hz
• Short Circuit, DC-Offset and Thermal Over load Protection Circuitry
• Diagnostic LED' s: Green- Power, Red- Standby I Fault
• Remote Input Level Control (For subwoofer channel) w/5 Meter Cable
Specifications
• Load Impedance- 2/4 Ohm
• Frequency Response-10-30kHz (Subwoofer-16-160Hz),-3dB
• THD+N@ 1kHz, 5 Watts -0.02%, 4-0hm, 14.4VDC
• Stereo Separation @ 1kHz - >6 Od B
• Signal to Noise Ratio-> 100dB (Rated Power)
• Input Sensitivity- 400m V-SV
• Input Impedance- 20k Ohm nominal
• Fuse- 2 x 30 Amp ATO Fuses
• Size- L12.8" x H 2.0" x W8.1"
• Weight- 7.0 lbs
Power Output
RMS Power Output@ 2% THD+N, 1KHz, 14.4vdc
• 60 x 4 Watts, 4-0hms
• 90 x 4 Watts, 2-0hms
• 190 x 2 Watts, 4-0hms Bridged Stereo
• 230 x 1 Watts, 4-0hms Subwoofer
• 400 x 1 Watts, 2-0hms Subwoofer
2