Advertisement
This symbol is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions.
This symbol is intended to alert the user to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may be of sufficient magnitude to constitute a
risk of electrical shock.
CAUTION: To reduce the risk of electrical shock do not remove the cover or back of this
unit other than to set camera address and baud rate. No user serviceable parts are inside.
CAUTION: To prevent electric shocks and risk of fire hazards, do not use other than
1. UNPACKING and HANDLING
Each unit is shipped assembled and factory tested.
Ensure that all accessories are removed from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose.
damaged or defective please contact your distributor or Securitytronix at 1-610-429-1511 for
assistance.
3.
SPECIAL ATTENTION
a. The installer must comply with electrical safety standards. There must be sufficient
space between the camera's power supply and video line and any high voltage
equipment and/or cables.
b. To help ensure the camera's life and proper operation do not point the camera
towards the sun or strong light.
c. Do not install the camera in an environment where the temperature is above 122° F.
d. Do not install the camera near a magnetic field or a high-power motor.
e. Do not mount the camera near a radiator or heater.
f.
Only use a dry cloth to clean the camera. If there is dirt that is difficult to remove wipe
gently with a mild detergent. Never use strong or abrasive detergents.
g. A minimum 12VDC 700mA power supply must be used. AC power cannot be applied.
Using an AC or other incorrect power supply will damage the camera.
h. Only qualified installers are allowed to install, test and disassemble the camera.
i.
The camera is a low voltage product. If installed outdoors proper safety and lightening
grounding are required.
v2.2 8/11/11
INSTALLATION AND OPERATION
specified power source.
If equipment appears to be
3
Advertisement
