Brewing Coffee; Programming Auto Start - Remington icoffee Care Manual

Brewing Coffee

Fill reservoir with desired amount of water and add an appropriate
amount of your favorite ground coffee to the brew basket. Ensure drip
basket and brew basket are pushed down and firmly seated. Insert brew
basket lid into the brew basket. Close water reservoir lid. Place carafe on
warming plate and press the ON/OFF button. Display will show "HEATING
WATER" and an "ON" animation indicating brewing is in progress. To halt
brewing, press ON/OFF again.
Note: If brew basket lid is not in place the brewing process will not begin.
You will be alerted by a tone, and the display will prompt, "Put Lid On."
Note: If water reservoir is empty the brewing process will not begin. You
will be alerted by a tone and the display will prompt, "Add H2O."
Note: If brew basket lid is removed while brewing is under way, brewing
will pause, you will be alerted by a tone, and the message "Put Lid On"
will be displayed. The iCoffee brewer will remember where it was in the
SteamBrew cycle for 20 minutes. If 20 minutes have passed before the
TM
lid is closed, the SteamBrew
Note: When brewing is complete the end-of-brewing Mozart tone will
sound and the "HEATING WATER" message on the display will be
turned off and the brewing animation will end. The "ON" indicates carafe
warming plate is on and will remain on (for up to two hours).
Note: The Mozart tone can be turned off/on if desired by pressing the
minute/music
delayed brewing mode.

Programming Auto Start

The iCoffee brewer can be programmed to start brewing at a pre-
selected time. To set the auto start time, press the auto start
The display will show the current auto start time along with the message
"SET AUTO START." Press the
until the desired auto start time is shown. Make sure that the time is set
correctly for am
(or simply wait for 10 seconds) to turn on auto start. The auto start button
will light up. To turn off auto start, press the auto start button again.
Note: If brew basket lid is not inserted into the brew basket, or if there is
no water in the Brewer reservoir, the auto start time cannot be set nor can
the auto start feature be turned on. Instead the display will prompt to "Put
Lid On" or "Add H20."
Note: The auto start button must be pressed again each day to activate
the delayed brewing feature. This prevents iCoffee from brewing when not
specifically desired.
cycle will end.
TM
button when Brewer is not brewing or in the auto start
or pm auto start. Now press the auto start button again
U
SING
(Delayed Brewing)
(hour) and (minute) buttons
Section 3
Y B
OUR rewer
button.
auto
start
11