Remington icoffee Care Manual page 10

Section 2
P
REPARING
Step 1- Remove Labels & Clean
Remove all adhesive tape and labels from Brewer surfaces. Clean the
carafe, carafe lid and removable drip and brew baskets.
Step 2 - Plug in & Set Clock
Plug power cord into outlet. A flashing message "SET CLOCK" and 12:01
am will be displayed. This is the Brewer asking for its clock to be set.
Press the
time and am or pm indicator is
shown.
Now press the clock
lock in the correct time-of-day.
The clock can be set at any time
when the Brewer is not brewing or in
the auto start delayed brewing mode
by pressing the clock
Note: Clock should be set before brewing or using the auto start feature.
Step 3 - Clean & Sanitize Brewer
Fill carafe to 12 cup mark and pour into water reservoir. Ensure drip and
brew baskets are pushed down and firmly seated. Insert brew basket
lid. Close water reservoir lid. Place carafe on warming plate and press
the ON/OFF button. Brewer display will show "HEATING WATER" and
an animation indicating brewing/sanitizing cycle is in progress. To halt
brewing/sanitizing cycle, press ON/OFF again.
Note: If brew basket lid is not firmly inserted into the brew basket the
brewing/sanitizing process will not start. Instead the display will prompt,
"Put Lid On."
Note: If water reservoir is empty the brewing/sanitizing process will not
start. Instead the display will prompt, "Add H2O."
If brew basket lid is opened during the brewing/sanitizing it will stop, you
will be alerted by a tone and the message "Put Lid On" will be displayed.
Brewer will remember where it was in the brewing/sanitizing cycle for 20
minutes. If 20 minutes have passed before the lid is closed, brew cycle
will end.
When brewing/sanitizing is complete the end-of-brewing Mozart tone will
sound and the "HEATING WATER" message on the display will be turned
off. Now press the ON/OFF button to end the brewing/sanitizing cycle.
10
Y B
OUR rewer
(hour) or (minute) flashing buttons until the correct
button to
button.