Pro-Form ZE9 PFEL70909.1 User Manual page 11

12. See the upper drawing. See HOW TO PLUG
IN THE POWER CORD on page 12 and plug in
the Power Cord (133). Next, make sure that the
Reset/Off Switch (37) is in the "on" position.
See the lower drawing. Press the Quick Power
Ramp 10º button on the Console (not shown).
The Ramp (4) will then move downward to the
lowest incline level.
Attach the Upright (6) to the Frame (1) with four
5/16" x 1" Patch Screws (81) and four 5/16"
Split Washers (105).
13. Make sure that all parts of the elliptical are properly tightened. Note: Some hardware may be left over
after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical.
12
37
81
105
11
133
6
4
1
105
81