Advertisement
d) Configure a Label for that HomeSeer system. Click
Address to enter the IP Address or Domain of the
HomeSeer System.
e) Now that you have set up the connection address,
go ahead and enter in your Username and
Password for that server. There is no need to
change the port.
f) You can follow steps c-e for the remaining 3
connections.
g) If you go back to the main settings screen, there
are other options for setting up HSTouch.
h) Connection Mode allows you to choose a default
connection for each time you start HSTouch.
(HSTouch will no longer prompt to choose a
connection at the beginning.)
i)
Dim Systembar allows for the bottom systembar to
be dimmed. Font Scaling allows for changing the
scaling factor.
j)
Auto Size allows for auto-sizing of the project being
used for your device. Client Name will allow you to
change the name of your device's HSTouch Client.
(For use with HSTouch Designer). Zipcode is used
for weather.
k) Now that your Client has been set up, go back to
the Main Screen and go to the settings menu on
the bottom right. Click Exit. Now go to your app
drawer and click HSTouch. This will allow for any
changes to take place.
l)
You are now ready to control your home via your
device!
STEP #10
– MyHS Remote
Welcome to the new MyHomeSeer Remote. MyHS will allow you to access your HS3 system from anywhere without
having to touch your router. There are requires for MyHS to work. HS3 must be version 3.0.0.97 or later. HSTouch
Android client requires 1.0.0.76 or later. Please make sure to update to these versions. It is recommended that you
uninstall the application and then reinstall it from the Play Store/iTunes Store.
(This guide assumes you have HSTouch Server already set up. If you do not,
please refer to the HS3 Quick Start Guide on setting that up). Now, let's get
started!
To begin using MyHSRemote you will need to register your HS3 software with the
connected service.
Page 7
Advertisement
