Advertisement
Z-Troller (requires a Serial-to-USB Converter Cable)
a) Take your Z-Troller and put it into "exclusion mode" by pressing and holding the Delete button.
Troller requires AC power or battery power to perform these steps.
b) Position the Z-Troller within 1 – 3 feet of your Z-Wave device and press the network button or paddle on your Z-
Wave device. The LED display will say HOLD and then DONE. Your device has now been reset or removed from
your network.
Z-Stick
a) To put the Z-Stick into "exclusion mode", press and hold its round button for 3 seconds. The LED light will begin
to blink rapidly.
b) Position the Z-Stick within 1 – 3 feet of your Z-Wave device and press the network button or paddle on your Z-
Wave device. The blue LED light on your Z-Stick will glow solidly for about 2 seconds and then return to blinking
rapidly. Your device has now been reset or removed from your network.
STEP #6
– Importing, Editing and Controlling Your Z-Wave Devices
After you've created your Z-Wave network, you'll need to import that network into your HomeTroller, so that your devices
can be monitored and controlled. Here's how to do that:
Importing Z-Wave Devices
e) From the web interface, use the pull down menus to navigate to the Z-Wave Controller Management page
(PLUG-INS > Z-Wave > Controller Management).
f) Locate the "Z-Wave Interfaces" area and expand the section of your Z-Wave Controller. Open the "Actions:"
menu and choose "Import Node Info from Controller and Scan Devices".
g) Click the 'Start' button below the Actions menu. Your HomeTroller will now import your device information from
the Z-Stick. When done, you'll receive an acknowledgement such as "Finished with Z-Wave device
synchronization". Your Z-Wave devices may now be monitored and controlled from the HomeTroller!
Editing and Controlling Your Z-Wave devices
a) From the web interface, use the pull down menus to navigate to the Device Management Page (VIEW > Device
Management). Click the "Show All" button in the upper right hand area of the page. A list of all your devices will
now be displayed.
b) To edit the name, location and other properties of any device, click the Name.
c) To control the device, use the buttons in the Control column.
Page 5
Note: The Z-
Advertisement
