Installing The Baimobile Reader Driver - baiMobile 3000MP User Manual

This is displayed when the reader is powered-on without any card inserted. This can happen
if the user uses the 'OK' button to cause power-on without a card inserted or if they plug-in
the charger to the reader without the card inserted. This indication is displayed for a few
seconds before the reader will turn itself off.
"BAD CARD"
It is displayed while the reader is powering-on with a card inserted but the reader was
unable to get the card to return an ATR (Answer To Reset) after causing card Reset. This
indication is displayed for a few seconds before the reader will turn itself off.
"LOW BATT"
It is displayed during power-on if the battery is detected as having very little power
remaining. Once the reader is finished powering-on (booting), this indication is replaced
with normal LCD indicators. This indication can only be displayed as a result of the booting
self-checks. We don't quantify this threshold value in any way since it may be adjusted in
the future.

Installing the baiMobile Reader Driver

Install via BES
The baiMobile 3000MP Reader driver must be installed on your BlackBerry phone. This can
only be installed via a BES. You may verify that the driver is installed by, on your
BlackBerry phone, go to Work > App Manager > Device Monitor > Memory. You should
see the baiMobile listed:
Install via Javaloader.exe
Files required:
1. Javaloader.exe
2. baiSmartCardReaderDriver.cod
1. On your Windows computer, install both files in the C: directory
2. On your Windows computer, tether your BlackBerry OS7 phones via a USB cable.
3. Make sure that your phone is powered On
4. On your Windows computer, open the Command Prompt (In the Accessories
folder)
15