Technical Specifications - Arcam AVR250 Handbook

Technical specifications

Analogue audio inputs
Line input sensitivity
Overload margin
Input impedance
Analogue audio outputs
Level (at 0dB gain)
Maximum level
Impedance
Signal/Noise ratio (analogue input)
Signal/Noise ratio (digital input)
THD+N (analogue input)
THD+N (digital input)
Frequency response
Headphone impedance
Power amplifier
Continuous power output (4 or 8Ω)
any 2 channels driven
all 7 channels driven
THD at 80% rated power output
Video inputs and outputs
Input and output impedance
Composite video level
HF response to (-3dB)
S-video level (Y/C)
HF response to (-3dB)
HQ (component) video
level (Y/Cr/Cb)
level (R/G/B)
HF response to (-3dB)
Digital audio inputs
Coaxial connection (level/impedance)
Acceptable sampling frequencies
Digital output level/impedance
Trigger outputs
Output D.C. voltage level
(excl. RGB status)
Allowable load
Remote inputs and output
Signal
Coding
General
Mains voltage
Power consumption (maximum)
Dimensions W x D x H (including feet)
Weight (net)
Weight (packed)
Supplied accessories
E&OE. All specification values are typical unless otherwise stated.
Continual improvement policy
Arcam has a policy of continual improvement for its products. This means that designs and specifications
are subject to change without notice.
Radio interference
The AVR250 is a digital audio device which have been designed to very high standards of
electromagnetic compatibility.
The unit can radiate RF (radio frequency) energy. In some cases this can cause interference with FM and
AM radio reception. If this is the case, keep the AVR250 player and its connecting cables as far from the
tuner and its aerials as possible. Connecting the AVR250 and the tuner to different mains sockets can
also help to reduce interference.
EU COUNTRIES – These products have been designed to comply with directive 89/336/EEC.
USA – These products comply with FCC requirements.
AVR250
E-34
0.5/1/2/4V rms (2V rms normal)
+2dB
>22kΩ
2V rms
3.5V rms
600Ω
100dB unweighted (measurement bandwidth 22kHz)
100dB unweighted (measurement bandwidth 22kHz)
90dB (0.003%) (measurement bandwidth 22kHz)
90dB (0.003%) (measurement bandwidth 22kHz)
20Hz—20kHz (±0.25dB)
390Ω
90W (20Hz—20kHz @ 0.2% THD)
70W (1kHz @ 0.2% THD)
0.02% (at 1kHz)
75Ω
1V
12MHz
1V/0.28V
12MHz
1V/0.5V/0.5V
1V/1V/1V
150MHz
0.5V/75Ω
44.1kHz, 48kHz and 96kHz
0.5V/75Ω
12V ±1V
30mA max. (min. 400Ω)
modulated 36kHz carrier
Philips RC-5
110V and 230V (switchable)
1200VA
433 x 420 x 145mm
16.2kg
21.4kg
Mains lead, CR80 remote control, 2 x AA batteries