Lenovo 3000 G430 User Manual page 34

Lenovo 3000 G430-G530 UG V1.0_en.book Page 26 Tuesday, July 1, 2008 7:51 PM
Chapter 2. Using Your Computer
Changing or Removing the Supervisor Password
To change the password, do the following:
1
Select Set Supervisor Password, and press the Enter key. The Set
Supervisor Password window opens.
2
Choose your Supervisor password, which can be from one to eight
alphanumeric characters in any combination. Select Enter Current
Password and type in the correct password. Then press the Enter key
once to move to the Enter New Password field, type in a new
supervisor password.
3
Press the Enter key once to move to the Confirm New Password field.
Retype the password you just entered to verify it.
4
Commit your password to memory, and press the Enter key.
To remove password, do the following:
1
Select Set Supervisor Password, and press the Enter key.
2
Select Enter Current Password and type in the correct password, and
finally press the Enter key thrice.
Note:
Make sure Password on boot is set to Enabled if you desire password
protection at power on.
26