Table of Contents
Advertisement
Hoffmann BH 556 Lipping Planer
5. Operation
1. Initial Set-Up
D
ISCONNECT ELECTRICAL POWER SUPPLY BEFORE ATTEMPTING ANY ADJUSTMENT OR MAINTENANCE WORK
With a straight edge, check if blades are in line with base plate. Use two small Allen screws in knife
clamping plate to adjust blade up or down, if necessary. Blades should be in-line with base plate and
project not more than 1.1mm above cutterhead body. (see drawing B)
Attach side handle (1) on cutterhead housing.
2. Operation
a) Set machine on panel and connect power supply.
b) Hold machine with main handle (2) and lift cutterhead off the panel with side handle (1).
Cutterhead must be clear off panel before machine is switched on!
c) Switch on machine.
d) Using two fingers, pull back blade guard (3) to expose rotating cutterhead.
e) SLOWLY lower machine onto panel.
f)
To stop, lift machine off panel.
g) Release power switch and blade guard.
h) Set down machine only after cutterhead has come to a complete stop.
Hoffmann Machine Company, Inc.
Phone: (828) 430 - 4510
- 3 -
1386 Drexel Road
Fax: (828) 430 - 4620
www.Hoffmann-USA.com
Valdese, NC 28690
e-mail: info@Hoffmann-USA.com
!
Advertisement
Table of Contents
