Pride Mobility REVO Owner's Manual page 30

V I I .
FRONT-TO-BACK SEAT ADJUSTMENT
You can reposition the scooter’s seat forward or rearward to one of three settings, to adjust the distance between
the seat and the tiller.
1. Remove the seat from your scooter. Refer to VIII. “Disassembly and Assembly.”
2. Remove the four bolts that fasten the seat to the seat platform. See figure 11.
3. Align the seat platform with the desired set of holes on the seat.
4. Replace and tighten the four bolts securely.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to one of three different
heights. See figure 12.
1. Remove the seat from your scooter. See VIII. “Dis-
assembly and Assembly.”
2. Use the attached ring to pull and remove the detent
pin from the lower seat post.
3. Raise or lower the upper seat post to the desired
seat height.
4. While holding the upper seat post at that height, match
up the adjustment holes in the upper and lower seat
posts.
5. Fully insert the detent pin.
6. Replace the seat.
30
C O M F O R T
www.pridemobility.com
A D J U S T M E N T S
ADJUSTMENT
HOLES
DETENT
PIN
Figure 12. Seat Height Adjustment
Revo/Rev A/December 2003