Allied Air 4SHP13 series Installation Instructions Manual page 19

Preservice Check
If your system fails to operate, check the following before
calling for service:
Check to see that all electrical disconnect switches are
ON.
Make sure the thermostat temperature selector is properly
set.
Make sure the thermostat system switch is properly set.
Replace any blown fuses, or reset circuit breakers.
Make sure unit access panels are in place.
Make sure air filter is clean.
Locate unit model number and have it handy before
calling.
Job Name _______________________________
Job Location _____________________________
Installer _________________________________
Unit Model No. ______________
Service Technician ________________________________________
Rated Load Ampacity ________
Maximum Fuse or Circuit Breaker ________________________
Electrical Connections Tight?
Indoor Blower RPM _____________
Outdoor Coil Entering Air Temperature _____________
Discharge Pressure ___________
Refrigerant Charge Checked?
Refrigerant Lines: Leak Checked?
Service Valves: Fully Opened?
Thermostat: Calibrated?
506762-01
Start-Up and Performance Checklist
Serial No. ___________________
Compressor _______________
Indoor Filter Clean?
S.P. Drop Over Indoor (Dry) ____________
Vapor Pressure ____________
Outdoor Fan Checked?
Properly Insulated?
Caps Tight?
Properly Set? Level?
Issue 1143
Job No. ________________
City ___________________
City ___________________
Nameplate Voltage ______________
Outdoor Fan ___________________
Supply Voltage (Unit Off) ________________
Voltage with Compressor Operating _____________
Date ______________
State ______________
State ______________
Page 19 of 24