Table of Contents
Advertisement
Hood is designed for installation under a
kitchen cabinet. See Fig. 1 for details.
1. Prepare duct location on hood (vertical).
2. Measure and cut out duct and electrical
openings in cabinet or wall to match up with
the hood. Ducting and electrical dimensions
can be found on Page 7.
Note: Makesure duct opening is large
enough to apply aluminum duct tape.
3. Reinforce cabinet bottom with wood strips
if additional strengthening is required or if
cabinets are framed.
4. Remove bottom panel from hood using a
Philips head screwdriver to remove each of
the (3) screws. Also remove lighting harness
by pressing in on the clip to release the
lights from the internal wiring.
5. Install (4) wood screws to cabinet bottom
by following the installation screw hole
dimensions on Page 7. These screws will
be used to secure the hood to the cabinet.
6. Lift hood onto screws located on cabinet
bottom and lock into place. Make sure all
(4) key-holes cover the screws. Tighten
each screw to secure hood to cabinet.
7. Install electrical.
8. Install duct work and seal with aluminum
duct tape.
9. Power up hood and check for leaks around
duct tape and test all functions.
10. Reinstall bottom panel and re-connect
lighting harness.
11. Slide residue cups into their openings on the
bottom of the hood. Install safety grilles over
each blower opening and secure with the
two safety grille screws.
Fig 1
9
Advertisement
Table of Contents
