Control Elements - Behringer EUROLIGHT LD6230 User Manual

EUROLIGHT LD6230
Various LD6230 control elements are described in this chapter. All controls and connectors are described in detail, and you also
get useful advice on how to use them in different applications.
Ventilation openings are located on the front panel. Their
position at the front assures that hot air does not enter the
inside of your rack, causing equipment failure or damage.
+
There is an automated fuse for each of the six dimmer
circles. These fuses engage in the event of overload or
short circuit.
Use the CHANNEL key to shift between the six dimmer
channels. When used in combination with the CONFIG key
(see ), you can select different operating modes (DMX,
ANALOG and MANUAL).
When your LD6230 works in DMX mode, use the 5-pole
DMX512 IN-XLR connector to connect DMX512 control
signals (see ch. 2.2 “DMX mode” and ch. 4.1 “Digital DMX
connector”).
You can relay the DMX control signal to additional dimmer
packs by using the 5-pole DMX512 OUT XLR connector. If
the dimmer is at the terminal end of a DMX chain, place a
terminator at the DMX output of the dimmer pack to avoid
signal bounce (use a terminator with the resistance of 120 Ω
between pins 2 and 3).
You can connect an analog 0 - 10 V control signal to the
8-pole ANALOG IN DIN connector (see ch. 2.3 “ANALOG
mode” and ch. 4.2 “Analog connector”).
6

2. CONTROL ELEMENTS

Fig. 2.1: EUROLIGHT LD6230’s front panel
Fig. 2.2: EUROLIGHT LD6230’s rear panel
2. CONTROL ELEMENTS
Use the UP and DOWN keys to navigate through individual
menus.
The CONFIG key is used to activate the configuration
mode (see ch. 2.1) and to select individual menus. When
used in combination with the CHANNEL key (see
can select different operating modes.
The LEDs to the left of the display have two purposes:
supply phase status indication (L1, L2 und L3) and indication
of the operating mode you selected (DMX, ANALOG and
MANUAL).
The 3-digit DISPLAY shows the values to be edited.
The LEDs to the right of the display relate to the individual
menus in the configuration mode. Depending on the selected
function, the corresponding LED lights up.
This is the cable slot for connecting your lighting equipment
(see INSTALLATION INSTRUCTIONS).
This is the cable slot for the power supply (see
INSTALLATION INSTRUCTIONS).
The cooling fan is located here.
SERIAL NUMBER. Please take a few minutes and send us
the completely filled out warranty card within 14 days of
the date of purchase. Otherwise, warranty claims may be
rendered invalid. You may also register online at
www.behringer.com.
), you