Specifications - Whitfield Advantage Optima 3 FS Installation And Operation Manual

SPECIFICATIONS

Flue Size
Width, Overall
Depth, Overall
Depth, Overall w / 3" tee
Height
Floor to Rear
Flue Center
Facing back of unit,
outside edge of left side
to center of rear
flue outlet center
Floor to Rear
Outside Air Inlet
Located on center-
line of pedestal back
Facing back of Unit
outside edge of right side
to center of air inlet
Floor Protection
Requirements
Standard Features
Hopper Capacity
Burn time
Fuse, Control Board
Fuse, Igniter
Heat Input (BTU's per hour)
Overall Efficiency
Emissions
Shipping Weight
Room Air Blower
Auger Motor
Exhaust Blower
Fastfire Igniter
Options
- Optima 2 FS
3" / 76mm Rear
23" / 584mm
22 3/4" / 578mm
28 1/2" / 724mm
28 5/8" / 727mm
11 1/4" / 286mm
6 1/2" / 165mm
5" / 127mm
11 1/2" / 292mm
+ Front and Sides: 6"/152mm
Back: Up to 6" / 152mm
Fastfire Self Igniter
Wall Thermostat (wire in-
cluded)
55 lbs.
♦ 15-37 hours
5 Amp, 250 volt, 3AG *
6 Amp, 125 volt *
♦ 13,000-32,000 BTU / hr
75-81%
♦ 0.4 gr / hr (varies w/size
and type of fuel) EPA ex-
empt.
215 lbs.
150 CFM; .8 Amps,
2175 rpm
1 RPM; .4 Amps
95 CFM: 1.0 Amps,
2880 rpm
4.35 Amps,
Nickel or Gold Trim Kits
4" Quick Disconnect
Log Set
28 5/8"
11 ¼"
Note: Dimensions shown are approximations only (+/- ¼")
+ Non-combustible floor protection is required (see
Floor Protection, page 5). When installed at clear-
ances less than 6", the floor protector is only re-
quired to extend to the wall.
♦ Fuel delivery and burn times will vary depending
on size and type of fuel used. Estimated heat in-
put based on fuel value of 8400 BTU per lb.
* Fuses are rated as fast blow.
PAGE 34
BACK VIEW
23"
6 ½"
11 1/2"
5 1/8"
SIDE VIEW
28 1/2"
w/clean-out tee
22 3/4"
8 ¾"