Vinobox 110 GC User Manual page 6

 Replacing Your LED Light
Please remove 2 the top shelves. (Attention: LED light is covered by electrical box.)
•
Please take out lock screw by "+" type head screwdriver first, then take out the light cover.
•
(Fig.A)
Please pull out Housing 4 from 6 of LED light board. (Fig. B)
•
Please take out 2pcs of screw 5 by "+" type head screwdriver. (Fig.C)
•
Please pull out LED light board 6 from light cover. (Fig.D)
•
Please replace new LED light according above method.
•
1. Inner liner
2. Lock screws
 Cleaning Your Wine Cooler
Turn off the power, unplug the appliance, and remove all items including shelves and rack.
•
Wash the inside surfaces with a warm water and baking soda solution. The solution should be
•
about 2 tablespoons of baking soda to a quart of water.
Wash the shelves with a mild detergent solution.
•
Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
•
electrical parts.
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry
•
with a clean soft cloth.
 Power Failure
Most power failures are corrected within a few hours and should not affect the temperature of
•
your appliance if you minimize the number of times the door is opened. If the power is going to be
off for a longer period of time, you need to take the proper steps to protect your contents.
 Vacation Time
Short vacations: Leave the Wine Cooler operating during vacations of less than three weeks.
•
3. Lamp cover
4. Housing
6
5. Screws
6. LED light