Operating Your Wine Cooler - Vinobox 110 GC User Manual

 Installation of Your Wine Cooler
This appliance is designed to be for free standing installation only.
•
Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded.
•
To level your Wine Cooler, adjust the front leveling leg at the bottom of the Wine Cooler.
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator,
•
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
Avoid locating the unit in moist areas.
•
Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under
•
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Products service center.
 Attention
Store wine in sealed bottles.

Do not overload the cabinet.

Do not open the door unless necessary

Do not cover shelves with aluminum foil or any other shelf material which may prevent air

circulation.
Should the wine Cooler be stored without use for long periods it is suggested, after a careful

cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid
possible formations of condensation, mold or odors.
 Reversing the Door Swing of Your Appliance
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side.
 How to remove the Shelves
To prevent damaging the door gasket, make sure to have the door all the way opened when
•
pulling the shelf out of the rail compartment.
For easy access to the storage content, you must pull the shelf approximately 1/2 out of the rail
•
compartment, however this unit was designed with a plastic post on each sides of the shelf track
to prevent bottles from falling.
When removing the shelf out of the inner rail, make sure to remove all items first. Then move the
•
shelf to the position where the notch of shelf is exactly under the plastic post and lift the shelf. In
order to replace the shelf, repeat steps described above in reverse.

OPERATING YOUR WINE COOLER

3