Installation Instructions - HAMPTON BAY 493-660 Instruction Manual

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
3ea Wire Connectors (#11)
1ea Mounting Strap (#14)

INSTALLATION INSTRUCTIONS:

1. Screw the two Mounting Screws (#13) into the Mounting Strap (#14). Mount the
Mounting Strap (#14) to the Outlet Box (#10) using the two Outlet Box Screws
(#12). [Make sure the heads of the Mounting Screws (#13) are facing outside when
the Mounting Strap (#14) is attached to the Outlet Box (#10).]
2. Wrap the ground wire from the fixture around the Ground Screw (#15) on the
Mounting Strap (#14), and then connect the ground wire from the fixture to the
ground wire from the Outlet Box (#10). Connect the white wire from the fixture to
the white wire (neutral wire) from the Outlet Box (#10). Connect the black wire
from the fixture to the black wire (live wire) from the Outlet Box (#10). Cover the
three connections using the three Wire Connectors (#11). Wrap the three wire
connections with electrical tape for a more secure connection. Position the wires
back inside the Outlet Box (#10). Note: If you have electrical questions, consult
your local electrical code for approved grounding methods.
3. Place the Canopy (#1) over the Outlet Box (#10). Allow the heads of the Mounting
Screws (#13) to come out through the large ends of the keyholes on the Canopy
(#1). Twist the Canopy (#1) clockwise until the heads of the Mounting Screws (#13)
slide into the narrow ends of the keyholes. Tighten the Mounting Screws (#13) to
secure the Canopy (#1).
4. Before completing Installation, please return to Assembly Instruction #4.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.
Page 6
2ea Outlet Box Screws (#12)
1ea Ground Screw (#15)
2ea Mounting Screws (#13)