Simplicity LTH series Service Manual page 94

6 General Repair
6B Hand Controls Repair
M
K
L
J
C
B
F
D
E
Figure B–22. Front/Rear Shift Rod Assembly
- Hydro
Parts List
A. Rear Shift Rod
B. Spacer
C. 11/32 x 1-1/8 Washer
D. 5/16 Lockwasher
E. 5/16-18 Hex Nut
F. 5/16 Plain Washer
G. Spacer
H. Control Lever (Transmission)
I. 5/16-18 x 1-3/4 Hex Capscrew
J. 17/32 x 1-1/4 x 5/64 Thk. Washer
K. Cotter Pin
L. Front Shift Rod
M. 5/16-18 x 1-1/4 Carriage Bolt
N. 5/16-18 X 1 Carriage Bolt
7. See Figure B–23. Unscrew the hex nut and related
hardware used to connect the shift pivot assembly to
the front shift rod.
8. The shift pivot assembly may now be removed from
the shaft, allowing the front shift rod to be removed.
9. Inspect the shift pivot assembly for wear, corrosion,
or other damage, giving particular attention to the in-
side surface of the pivot tube. Replace the shift pivot
assembly if worn or corroded.
10. Check the front shift rod for cracks, corrosion, or
other damage, and replace if necessary.
C C
A
M
B
F
B
E
N
I H
G
E
D
Figure B–23. Disassemble Shift Pivot/Front Shift
Rod Assembly
Figure B–24. Disassemble Rear Shift Rod From
Transmission Shift Lever
11. If no additional service is required, reassemble parts
in reverse order of assembly, and make neutral and
return-to-neutral adjustments as shown in the adjust-
ments section of this manual.
12. See Figure B–24. If necessary, the rear shift rod may
also be removed and replaced at this point. Remove
the hex nut and related hardware that secure the rear
shift rod to the speed control lever on the transmis-
sion.
6 - 26
Front Shift Rod
Shift Pivot
Rear Shift Rod