Simplicity LTH series Service Manual page 185

23. Remove the two swash plate bearings from the hous-
ing.
24. Inspect the swash plate bearings for wear or scoring.
25. Measure the thickness of the bearings:
Thickness: 1.45–1.55 mm (.057–.061")
Minimum thickness: 1.30 mm (.051")
26. Unhook the control shaft centering spring from the
fulcrum pin.
27. Remove the centering spring from the control shaft.
Figure C–35. Remove Swash Plate Bearings
Figure C–36. Inspect Swash Plate Bearings
Figure C–37. Remove Centering Spring
7 - 55
7 Transmission Repair
7C Tuff Torq K60
Control Shaft
Centering Spring
Fulcrum Pin