Do you have a question about the D3939 and is the answer not in the manual?
Questions and answers
Paul Alexander
February 13, 2025
Hi got no power going to unit change fuse in plug and check wiring on plug
1 comments:
Mr. Anderson
February 13, 2025
The Zennox D3939 unit is automatically powered when connected to the mains. If there is no power after changing the fuse and checking the wiring, possible reasons could include: 1. The device is not properly connected to the mains. 2. The power outlet is faulty. 3. The internal components of the unit are defective.
It is advised not to attempt maintenance while the device is connected to the mains. If the problem persists, contact customer service and do not use the unit in a defective state.
Page 1
This device is automatically powered when connected to the mains, and you should never attempt any maintenance when the device is connected to the mains. D3939...
Page 2
If this product develops trouble, contact customer services, and do not use the product in a defective state.
Page 3
Check the stylus is correctly positioned in the centre (third photo is correct). The stylus is located in the centre. Do nto touch the needle as it could injure your hand.
Page 4
Discs To move a CD from its storage case, press down on the centre of the case and lift the CD out, holding it carefully by the edges. If the CD becomes dirty, wipe the surface from the centre hole outward towards the outer edge with a soft, dry cloth.
Page 5
For optimal FM reception make sure you fully extend the built-in FM antenna wire located at the lower back of the unit and move it around the station you have tuned in is being Rotate the VOLUME knob clockwise or received clearly.
Page 6
NOTE: When a cassette tape is inserted, the radio/phono/CD/AUX will automatically shut off.
Page 7
Place a disc on the tray with the printed label face up. The CD must be placed in the centre of the disc tray. If the CD is not correctly loaded, it may not be possible to open the tray again once it has closed, so you should ensure the disc is always centered on the tray.
Page 16
2. Move cursor to the wave grpahic area, left click mouse and hold then drag from left to right. You can see the time bar colour changing to grey (highlighted). Release the mouse when the highlighted time bar has reached 1:45 (end of first song).
Page 18
Use the attribute controls button at the top of the screen to go to the beginning, Play, Record, Pause, Stop and End. Use the File, Edit, View, Project, Generate, Effect and Analyze menus to Save, Export and edit the music.
Page 19
If you couldn’t find the “Core Audio (USB Audio CODEC)” from the Device list, close the Audacity Software and re-open then try again or ensure the turntable is connected to the computer.
Page 21
In case of trouble with the unit, please look through the guide below and see if you can solve the problem by yourself before calling your dealer.
Need help?
Do you have a question about the D3939 and is the answer not in the manual?
Questions and answers
Hi got no power going to unit change fuse in plug and check wiring on plug
The Zennox D3939 unit is automatically powered when connected to the mains. If there is no power after changing the fuse and checking the wiring, possible reasons could include:
1. The device is not properly connected to the mains.
2. The power outlet is faulty.
3. The internal components of the unit are defective.
It is advised not to attempt maintenance while the device is connected to the mains. If the problem persists, contact customer service and do not use the unit in a defective state.
This answer is automatically generated