Wireless Remote Controller; Clock Button; Reset Button - Mitsubishi Electric PLFY-P32VBM-E Technical & Service Manual

3-2. WIRELESS REMOTE CONTROLLER

display
OPERATION MODE display
Operation mode display indicates which
operation mode is in effect.
display
The vertical direction of air flow is indicated.
display
FAN SPEED display indicates which fan
speed has been selected.
ON/OFF button
The unit is turned ON and OFF alternately
each time the button is pressed.
FAN SPEED SELECT button
Used to change the fan speed.
MODE SELECT button
Used to switch the operation mode between
cooling, drying, heating, auto and fan mode.
CHECK-TEST RUN buttons
Only press this button to perform an
inspection check or test operation.
Do not use it for normal operation.
VANE CONTROL button
Used to change the air flow direction.
OCH413D
CHECK TEST RUN display
CHECK and TEST RUN display indicate that
the unit is being checked or test-run.
MODEL SELECT display
Blinks when model is selected.
CHECK TEST RUN
MODEL SELECT
AMPM
AMPM
NOT AVAILABLE
ON/OFF TEMP
FAN AUTO STOP
MODE VANE AUTO START
CHECK LOUVER
TEST RUN
SET RESET CLOCK
6
Lights up while the signal is transmitted to
the indoor unit when the button is pressed.
SET TEMP. display indicates the desired
temperature which is set.
CLOCK display
Displays the current time.
Displays when in timer operation or when
°C
setting timer.
"
Displays the order of timer operation.
"
Displays whether timer is on or off.
SET TEMPERATURE button sets any desired
room temperature.
TIMER CONTROL buttons
h AUTO STOP (OFF timer): when this switch
is set, the
automatically stopped at the preset time.
min
AUTO START (ON timer): when this switch is
set, the air conditioner will be automatically
started at the preset time.
h and min buttons
Buttons used to set the "hour and minute" of
the current time and timer settings.
LOUVER button
Changes left/right airflow direction.
(Not available for this model.)
display
display
TIMER display
" " " display
" " " display
buttons
air conditioner will be

CLOCK button

RESET button

SET button